| Main > Everything Else |
| 3D Printing : Arcade Edition Thread |
| << < (40/63) > >> |
| Howard_Casto:
It's looking good. Thanks for the link. |
| yotsuya:
--- Quote from: Howard_Casto on March 12, 2019, 12:50:01 pm ---It's looking good. Thanks for the link. --- End quote --- No problem. I need to overhaul my belts. I printed out this Ikea Lack Switchboard... found on #Thingiverse https://www.thingiverse.com/thing:3329766 And the holes for the buttons were a bit too ovally for my tastes. Anyone here use belt tensioners like this? anet a8 y belt tensioner found on #Thingiverse https://www.thingiverse.com/thing:2149867 |
| SammyWI:
--- Quote from: yotsuya on March 12, 2019, 01:51:02 pm ---And the holes for the buttons were a bit too ovally for my tastes. Anyone here use belt tensioners like this? anet a8 y belt tensioner found on #Thingiverse https://www.thingiverse.com/thing:2149867 --- End quote --- I use one similar but it doesn't have the printed threads - just uses a nut and screw for that part. I did add a zip tie around the outer part as it seemed to want to spread under load. It's been working fine. |
| yotsuya:
--- Quote from: SammyWI on March 12, 2019, 06:19:02 pm --- --- Quote from: yotsuya on March 12, 2019, 01:51:02 pm ---And the holes for the buttons were a bit too ovally for my tastes. Anyone here use belt tensioners like this? anet a8 y belt tensioner found on #Thingiverse https://www.thingiverse.com/thing:2149867 --- End quote --- I use one similar but it doesn't have the printed threads - just uses a nut and screw for that part. I did add a zip tie around the outer part as it seemed to want to spread under load. It's been working fine. --- End quote --- Cool, thanks for the feedback |
| nitrogen_widget:
I got my amazon basics pet-g in. First attempt was a carabeaner. 235c nozzel and 85C bed. A stringy mess but it printed. I adjusted nozzel temp up to 238c and played around with wall thickness and layer height plus resolution and some other settings I don't fully understand yet. LOL! and i only saw a little stringing at the beginning and heard the extruder clicking so I raised the Z height a tiny bit while printing (an option with my printer) and I think it looks good. I choose to make this to test things are solid and because I have a puck light and I think it looks cool. https://www.thingiverse.com/thing:3434805 Will report back on how the filament performed in a day or two when it's done printing. |
| Navigation |
| Message Index |
| Next page |
| Previous page |