Main > Woodworking

Need some outside the box thinking... joining wood at right angle

<< < (7/7)

Mike A:
I suppose. Rehab is for quitters.

ZTylerDurden717:
vaderag,

Sorry for necroing this thread, but I'm in the exact same situation with the vinyl wrapping and figuring out how to insert the wiring afterward.  I sent Ond a reply on the main thread so I'm waiting on his input.

So you ended up cutting a big enough hole in the CP bottom after it "curves" out to have enough free range access to screw/wire in the buttons/joysticks?  Was it like building a ship inside a bottle (please say no)?  How do you have the CP bottom hole covered after the wiring was done because I'm thinking I could board the hole with a really thin sheet of wood with threaded inserts.  How did you screw in the CP side attachments and was it after you were done wiring and applying the vinyl?


As always, I appreciate the help.

vaderag:
So my hole is actually two holes. I left a middle strut for stability. Additionally they're only deep enough to be covered once the CP is in place so they can't be seen.
The side panels I'm connecting with some tension clips from the CP to some screwed on wood.

I'll try snap some pics when I get chance

Sent from my Mi A1 using Tapatalk

ZTylerDurden717:
Thanks a lot!  A visual will definitely help.

Navigation

[0] Message Index

[*] Previous page