Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news


  

Author Topic: newb help  (Read 232 times)

0 Members and 1 Guest are viewing this topic.

arcadejuinkie

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 3
  • I want to build my own arcade controls!
newb help
« on: September 06, 2017, 11:06:20 pm »
Ok I know I'm a newb and I did try searching for my issue and didn't have any luck so hoping I can get some advice here..  I was able to do some trade work for mame system a few years ago and thus began my journey into this awesome hobby.  I never really had to work on the system but now I've done some upgrades....now I'm stuck and because I didn't build the system I'm a little lost on where to start.

My system was running fine on xp but for a number or reasons I decided to move to win7.  I did this by unhooking the old HD and putting in a new one and did a fresh install.  This leaves me the old drive as reference but a blank new drive for configs and software....but I don't know where to start.  My current problem is around my controls.

I have a controller card that reads  x-wiz ECO ST/MAX my problem is that when I try keywiz3w7 it says connection failed....I even tried the gp model as I also have two spinners and it says I don't have device installed.  So I'm lost...I don't know where to go to start setting up my button config so that I can use in gamex or hyper spin.  Can somebody help me out or point me in the right direction?  I couldn't find much help on their website so I'm turning to the group.  TIA!

krick

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1822
  • Gotta have blue hair.
    • Tank + Paladin = Tankadin
Re: newb help
« Reply #1 on: September 07, 2017, 10:31:30 pm »
Reach out to the folks at GroovyGameGear to get help with your encoder...

http://groovygamegear.com/webstore/index.php?main_page=contact_us

  
 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31