I have an
Aimtrak Lightgun without recoil and am trying to get it to work with a PS2 but it does not.
I have read through the setup guide and the PS2 guide but to no avail.
When I first tried it I could get into calibration mode by holding the the 2 buttons when turning the PS2 on but I couldn't do anything once I was there. I never saw any cursor and even though I could shoot (the screen flashed and I got a shooting sound), I couldn't do anything else.
I did manage to start Time Crisis II with the gun and it seemed that I could shoot things but only if I only made minute gun movements. The reload also worked when I moved the gun away from the screen.
I eventually found that the sensor was not working as the connector that connects to the sensor PCB was not fully connected. When using a mobile phone camera, I could not see the LEDs.
Once I pushed the connector on more securely the phone camera picked up the LEDs without any problems and continues to detect the sensors as being on/active.
I plugged it all back into the PS2 and again I could start calibration mode by holding the 2 buttons but again I could not see a cursor! I unplugged and re-plugged and since then I cannot even get into calibration mode. Nothing happens when I press the buttons.
Notes
The gun works perfectly on a PC. I can move the cursor and I can select items by pressing the trigger or if I configure the buttons I can use these to select.
Using the Aimtrak v2.0 config utility on my PC:
- SENSOR VIEW CHECK works (although the red dot moves in the opposite direction to gun i.e. left is right and up is down)
- SHOW DATA works. I can see the X and Y coordinates etc changing. Nothing appears in the Cal Status field
- Firmware: 9.19
- The gun is set for ID:1
- Calibrate works
- Button Assignments (changed numerous times), On and Off screen configs being the same and set as
- TRIG: Mouse Left
- LEFT: GP Button 1 with Enable Cal set
- RIGHT: GP Button 2 with Enable Cal set
- Tilt / Z Correction: Continuous
- Recoil: 2.5 (the gun does not have recoil)
- IR Gain: 4
- Disable Auto Gain: Checked
- Cal Delay (Secs): 5
- Emulate Mouse
As mentioned above, these are the current settings. I have changed all them to different settings previously.
I have also tested using both Time Crisis II and III and tested on both a Slim and Fat PS2.