Software Support > GroovyMAME

Model 2 Emulator and CRT Emudriver

(1/3) > >>

Nodoyuna:
Hi,
I'm pretty new to the "native resolutions world" :)
I've installed CRT Emudriver 2.0 on an ATI R5-230 graphics card and it's working really great
As the computer I have now is totally new, I need to install all emulators, and in the process, I'm trying to get the native resolutions for them
My main system is a 4:3 CRT TV set, and I also have a 4:3 PC CRT Monitor and a 4:3 PC TFT Monitor, so I have many possibilities covered
My windows is set to 640x480 interlaced mode with Windows 7 (windows says it's 640x480 at 30KHz)

I've read Model 2 has a resolution of 496x384 in progressive mode at 25KHz (I think)
I don't have that resolution on my system, so, can I generate it with WMMaker?
If so, it's enough to write " 486 x 384 @ 25.000000"?

About the original system, the screen was LCD or CRT?
Also, if I can get the native resolution, it should be better to run it in the VGA monitor instead of the CRT TV, right?

Thanks in advance

haynor666:
This is mode for 25 kHz monitors. Neither Your TV or PC monitor can not handle such mode.

Nodoyuna:

--- Quote ---This is mode for 25 kHz monitors. Neither Your TV or PC monitor can not handle such mode.
--- End quote ---

Hi
Thanks for the reply
So, what should be the better solution? (I mean the closest to the native resolution)

Recapnation:
The PC CRT monitor. You can try a mode close enough to the native one after understanding the monitor specs thingie and then tweak the geometry with the analog scaling buttons/OSD. You won't get full screen most likely, but not too far either.

But this is advanced stuff. If you're new to this, you should start with Groovy MAME, 15-kHz, 31-kHz, then getting the best geometry for every mode, mode editing...

(I'm not creating your account in Eiusdemmodi for now, by the way, sorry. Technical issues.)

Nodoyuna:

--- Quote ---But this is advanced stuff. If you're new to this, you should start with Groovy MAME, 15-kHz, 31-kHz, then getting the best geometry for every mode, mode editing...
--- End quote ---

Yes, thatīs me, starting with the most difficult things :D

Anyway, I'll try with the PC CRT monitor and see if I can get it
I've tried groovymame before, and it works well, except for some adjustements I need to make

One more question, can I use VMMaker with the CRT PC Monitor too, even if it's at 31KHz?

About the Eiusdemmodi account, I suposse I'll receive an email when it's done, right?

Thanks for the reply

Navigation

[0] Message Index

[#] Next page