Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Galaxy 3 problem  (Read 1912 times)

0 Members and 1 Guest are viewing this topic.

Karetaker

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 268
  • Last login:July 28, 2022, 08:19:40 pm
  • I want to build my own arcade controls!
Galaxy 3 problem
« on: January 12, 2017, 06:10:22 pm »
I believe I have a bad PCI card. My dart wasn't reading anything coming from the top of the dart board(LED & dart matrix). But while I was reseating the PCI card I also created a new problem. I knocked a plug out. This plug goes to the reset switch on the back of the machine. These machines don't like to come up if this plug is in the wrong place. There is a ten header pins with one cut off on the left side towards the back of the machine. The plug itself has a red and white wire. Anyone know where this goes?
Logged
Pages: [1]
  
Go Up
« previous next »