Arcade Collecting > Merit/JVL Touchscreen
Boot Issue With Megatouch XL Gold
ice2921:
You were able to get it without doing any of that stuff? By the way im getting invalid key warning now.
obcd:
Yes, I didn't had to bypass that cd protection, but my software version is not the gold but an older revision.
They only put that check in with the later versions.
Daddylonglegs figured it out the hard way but had someone patched the exe for him.
If you didn't change anything in the software, you might have a problem with your io card so that the dongle isn't read correctly.
ice2921:
--- Quote from: obcd on January 16, 2017, 03:22:03 pm ---Yes, I didn't had to bypass that cd protection, but my software version is not the gold but an older revision.
They only put that check in with the later versions.
Daddylonglegs figured it out the hard way but had someone patched the exe for him.
If you didn't change anything in the software, you might have a problem with your io card so that the dongle isn't read correctly.
--- End quote ---
Alright then I guess all of this was for nothing then. :(
obcd:
--- Quote ---Alright then I guess all of this was for nothing then.
--- End quote ---
That's a little short trough the corner.
You could try to fix your io card. often the problems are oxidated finger contacts. Rubbing the gold plated contacts with a pencil eraser sometimes helps. (Do it with the riser card as well.) Contact 60 spray might help. Inserting and removing the boards a couple of times could help as well.
Using the system with a harddisk or compact flash disk works much better and faster than using it with a cdrom.
It's definitly not a waste of time to do that conversion.
That harddisk message is fixable.
On some other posts, you might read someone managed to patch the exe so that the security dongle is no longer needed, but,
if your io board isn't working well, you will have sound problems and problems with the test and calibrate button. It won't save it's high scores and lose it's settings due to the nvram not being read correctly...
Pretty much any functionallity of the io board can become a problem.
ice2921:
I think that part of it is my I/O board but I need to see if someone has one. im guessing if I get a new one all I need to do is move my dallas/security key over?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version