Main > Everything Else

So ... 3d Printers....

<< < (284/284)

nitrogen_widget:
took the rest of the day to set this up.
now i'm printing on the stock hotend.
need to do input shaping then print some bigger models, check quality and decide if i want to switch to direct drive.

BadMouth:

--- Quote from: nitrogen_widget on March 02, 2025, 10:03:00 am ---i'm making this into a tap handle for a stranger things themed sour we are making for a beer show.

--- End quote ---

Understand that I am a nitpicker and can't help myself when I see room for improvement.   :blah:
I see a lot of little dots where the layer starts and ends.  On something like that which won't bee seen from the rear, I'd move the seam position to the back.
The seam will be a visible line, but the front will look really clean.
My apologies if your seam position is not set to random and I'm misinterpreting something in the picture.

nitrogen_widget:
seam position is random. i'll keep that in mind next time i print a figure.

Navigation

[0] Message Index

[*] Previous page