| Main > Everything Else |
| So ... 3d Printers.... |
| << < (264/284) > >> |
| nitrogen_widget:
--- Quote from: pbj on March 06, 2023, 08:59:25 pm ---Can you print me a set of blue ships for the table top game Plunder? I may resort to spray paint. --- End quote --- can't find a model specifically but i could probably clear the deck on this and add some holes. https://www.thingiverse.com/thing:16419 i'd need size of holes and dimensions of the ships. need to see how the model scales. Also, i take it the game is decent? was looking at it a while back. |
| RandyT:
--- Quote from: pbj on March 03, 2023, 07:51:31 am ---No pics = no prints --- End quote --- You asked for it :lol So I picked up a relatively cheap-ish S20 Ultra with a cracked back for a DIY handheld experiment. There's a couple of screen digs, but they aren't visible with the screen on. Everything else was in perfect working condition, including the amazing 6.9" OLED screen, which is bright and has zero burn-in, and the fancy cameras. But due to the splintery glass cracks on the back I needed to put a case on it. Unfortunately, even the thinnest one I could find which would still even out the camera hump, made it too thick to fit the channels in the BT controller I had laying around from a years-gone-by AliExpress Winter sale. Even though it worked, it looked and felt janky, and I was worried the S20 would fall out. 3D printing to the rescue. I'm especially proud of this one. Not only is it the largest thing I've printed to date, bed-width wise, it was "one and done" from design to print, which is something which almost always eludes me. Now, everything is solidly locked into place and it feels like a one-piece unit when assembled. The fancy cameras are even still clear and the buttons on the game controller can be used to snap photos. :) |
| BadMouth:
--- Quote from: RandyT on March 19, 2023, 02:12:47 pm ---So I picked up a relatively cheap-ish S20 Ultra with a cracked back for a DIY handheld experiment. --- End quote --- Check out ReDream emulator if you haven't already. PPSSPP as well, but I assume you already know about that one. Since I'm posting in this thread....pic of sink trays. (kitchen is WIP, hence the melamine scrap countertop.) EDIT: Also printed jigs to mount the cabinet hardware. |
| nitrogen_widget:
so lk5pro psu replacement was a bust. going with klipper and skr pico main board. rpi zero 2 will be the brains along with a 3.5" rpi touch screen. I have a rock64 i was going to use but i could only get the display on the screen without touch which honestly i'd be better off using an old tablet. so installing klipper now on the zero 2. have klipper installed on the pico. have pico default config and have a klipper config file from longer. so i'll match pins up to function and start with the mesh leveling. I do have a real BLtouch which bolts on but..babysteps. I get good adhesion doing the manual leveling. will update as i have time to work on this. also..umm bought a sidewinder X2 with 300x300 bed and direct drive. it was on sale. i need a large printer now to get some of my models done so... it prints really nice, has auto leveling with some bltouch type thing. i had to get it close manually then i ran the auto and its printing great also. :) |
| RandyT:
--- Quote from: BadMouth on March 19, 2023, 08:55:31 pm ---....pic of sink trays. --- End quote --- That's a slick use of otherwise wasted space. Nice work! |
| Navigation |
| Message Index |
| Next page |
| Previous page |