Arcade Collecting > Merit/JVL Touchscreen
megatouch rx keeps rebooting after cmos battery died
gmtransman2:
rx with a intel mb in it the cmos battery died replaced battery now just keeps rebooting. have reset date time and loaded defalts, saved before i exit cmos. replaced hard drive same thing. any ideas thanks
mahkeymike:
Where does it reboot and is there any error on the screen before it reboots? Reason being, if your IOboard isnt being detected it will cause a reboot loop. Any hardware change or failure will cause a reboot loop. If you replaced the hard drive, that would rule out corrupt data.
gmtransman2:
it has no red failed all green ok it goes all the way up to localhost login than reboots
gmtransman2:
last thing is says is
usb 2-1: usbsf: interface 0 claimed by usbtouchscreen while 'twdriver' sets config #1
than reboots and reboots???
lilshawn:
try going into the bios and loading the default configuration. sometimes something gets enabled or disabled in the bios that throws things into a boot loop.
double check that the computer is set to turn on after an AC power loss.
Navigation
[0] Message Index
[#] Next page
Go to full version