| Arcade Collecting > Restorations & repair |
| Which of these 2 silvers on a Robotron Restoration? |
| (1/2) > >> |
| 8BitMonk:
Looking for a little feedback, restoring a Robotron and debating which of these two silvers (Rustoleum Aluminum or Stainless Steel) to use. It's totally subjective, just looking for opinions. I'm leaning towards the darker, I think it's closer to the original and will hold up better. |
| Spyridon:
--- Quote from: 8BitMonk on October 10, 2016, 10:41:46 am ---I'm leaning towards the darker, I think it's closer to the original and will hold up better. --- End quote --- I'd go with the darker one as well. It should look really good once the red and blue are down on top of it. |
| 8BitMonk:
--- Quote from: Spyridon on October 10, 2016, 10:44:22 am ---I'd go with the darker one as well. It should look really good once the red and blue are down on top of it. --- End quote --- Thanks for the feedback. For anyone else stumbling upon this below are red/blue examples of the gamestencils.com colors and Rustoleum. I'm going with the rattle can Rustoleums for red/blue, gamestencils.com red is way off and blue is too bright. I'll start a restoration thread once I'm farther along. |
| 8BitMonk:
Don't know why this was moved to restorations, the purpose of the post was a general question about color choice, not about the restoration. :dunno |
| opt2not:
I think it's relative to restorations, as you're trying to match the original. |
| Navigation |
| Message Index |
| Next page |