So while i wait for name suggestions to come in, I was hoping I could get help with the base for the pedestal.
here is the basic layout, and a better view with text removed
I have the 16mm (0.6 inch) MDF base sitting on top of about 3-4 dollies that can each carry 100kg (220 pounds).
Using fusion 360 i was able to estimate the weight of the pedestal unit to be around 50 kgs (110 pounds). Im concerned that base that is holding all the weight of the control panel and its tower isnt strong enough. the design uses tabs and lips inserts in the same way that most "put it together yourself" kits do. These add some strength but are there more so that parts to line up and lock in effortlessly.
The tabs that interacts with the tower that will hold up the control panel should add extra strength. Stil I also plan to reinforce every butt joints with a lot blocks, nails, screws and glue. these aren't in the design as they will be added as needed when i assemble it. But no matter how much i reinforce the joints, if the MDF is too weak then its points less. It will break anyway.
So while doing my research, i saw builds where the base is really thick, and i wonder if my solution will be enough or it will break under the weight. should i use something stronger than MDF (maybe ply) for the base? I dont know if this is overkill as other cabinets I've looked at seem to have a really simple base. Also a pedestal cabinet won't have the weight of the TV or all the wood of a standup cabinet as well so it should reduce the load requirements of the base.
Does anyone have any advice?