Main > Raspberry Pi & Dev Board

Resolution issue(height) when out outputing to a Jpac

(1/1)

Gamer4life:
I spent some time today trying to get retropie to output a good height to my monitor. I started with a clean install and dropped tmnt in my mame folder. I made sure that everything work fine on my tv before moving it over to my cab.

Before I moved it over to my cab I modified the boot config to:

hdmi_cvt=320 240 60 1
hdmi_group=2
hdmi_mode=87

Everthing works fine, but my image is cut off at the top by a handful of pixels. In game and in retropie(see pic) I tried handful of things but I still cant get a full image. I am using a 25" k7000 with a hdmi to vga to the Pi. Any help would be appreciated.

Gamer4life:
Right after I posted this I found Floobs video on adjusting the border setting in the mame.cfg file that did the trick. Is there any other ways to go about it?

elvis:

--- Quote from: Gamer4life on October 02, 2016, 11:36:38 pm ---Right after I posted this I found Floobs video on adjusting the border setting in the mame.cfg file that did the trick. Is there any other ways to go about it?



--- End quote ---

There are overscan adjustments in mame4all as well as the RPi's boot configuration:

http://elinux.org/RPiconfig

Adjust both to the needs of your particular monitor.

Navigation

[0] Message Index