Main > Raspberry Pi & Dev Board

Raspberry Pi and Zero Delay

<< < (5/5)

MikeAlex:
No, they were all of the small kind...maybe an error on their part, I don't know...

ballboff:

--- Quote from: MikeAlex on June 24, 2016, 04:55:04 am ---No, they were all of the small kind...maybe an error on their part, I don't know...

--- End quote ---

too right it's an error.  They should have sent you this...

1 x Encoder Board
1 x USB Cable
1 x 5pin Cable for Joystick
1 x 5 Pin Joystick
8 x 30mm Push Buttons
2 x 24mm Push Buttons
13 x Wire Cables for Buttons

as listed on their article

MikeAlex:
Everything were as described except for the buttons. The good part is that I mostly needed the encoder and the joystick so, not much harm done!  :)

mike boss:
I picked up two RPi3 boards with 32GB SD cards and cases for $80 CDN (used off a local online resell site).
I plan on using one for a NintendoPI project, the other will be used in my Punch-Out bartop.

However I'm unsure if I should use my Zero Delay Encoder, KADE, or Ipac, all of which I have lying around.

I'm heavily leaning towards the ZDE as I think I could sell the KADE and Ipac to be honest.
And realistically I don't think Id use the ZDE elsewhere.

I thought I read prior that the ZDE had some lag ? Has anyone found this to be correct ?
Is the initial set up rather easy ? I'm very much a novice at this stuff.

Any info, advice, tips and tricks would be welcome.

Thank you

Navigation

[0] Message Index

[*] Previous page