Control panel CPO apply over material

[majoly]

I was planning on ordering from gameongrafix. I would paste the CPO over a 1/8" thick plexi.

Would there be a reason why I should not do that?

If no got a better idea?

[Malenko]

what?


you put the CPO on the CP, and if the CPO doesnt have polycarb coating you put plexiglass/persiplex over top of it.

[majoly]

MDF is CP, over my CP I would put plexi, and over my plexi i would put the CPO

[DaveMMR]

The overlay goes on the wood/metal - the plexi goes above it all.   The plexi's purpose is to protect the artwork typically. If you put the overlay on the plexi you're defeating its purpose.

[majoly]

my reason on doing that is for physical limitations.

I need to apply my CPO on a 1/8" thick surface.

And from what Ive been told, game on grafix work wont require me to put a plexi over the CPO.

metal is the best option I guess?

[DaveMMR]

May I ask why the surface needs to be 1/8"?  I'm not following. I don't think the overlay cares about thinkness.

[majoly]

For my CP to be flat with the frame, the surface where I apply the CPO, to sit on all sides has to be 1/8 thick. Anything thicker will make the surface not even with the rest of the frame.

So from all choices I have

Plywood 1/8, plexi 1/8, metal 1/8, is plexi a bad choice or not to apply a CPO over

[DaveMMR]

I suppose you can apply it to the plexi if that's what you like - but if you're cutting holes wood would be easier.  (So long as you have support underneath. That's thin wood.)


Plexi/lexan, typically, is used as a "protector".  But if you have a reason to do it then it's fine - just not the usual way of using it which is why we were a tad confused.