Main > Monitor/Video Forum
Orion R10CPDB-DH Mono Chrome 10" CRT...please help.
lilshawn:
--- Quote from: ed12 on February 04, 2016, 02:20:52 pm ---good call :)
side note
did u catch the burning on the monitor edge connector ?
ed
--- End quote ---
that could be a shadow from the camera flash, but I wouldn't discount it being an issue just yet.
first step is to measure the voltage coming in to the connector to make sure it's 110 or 120 volts (or whatever your normal line voltage is for your house.
ed12:
well when asked i did do a double take
>Burning on the edge connector? I did not catch that...where do you see that?<
thought could be dirt/dust/cam?
but i like u will not leave it out..
one of the thing's i caught from that froum i posted on, was the burning on the edge connector >ground<
which happens to be the frist 2 to the left and right of that edge connector
ed
ScottHerriman:
26 vdc at B+
ScottHerriman:
Service manual says it needs 55 volts and I am only getting 26. Does this mean a bad PS or would something else be in order?
ed12:
wow i thought this thread went dead ?
if u un-plug the power feed,dose the +26 go up ?
ed