Arcade Collecting > Merit/JVL Touchscreen

megatouch EVO wont load, Please help!

(1/2) > >>

clc1986:
I recently bought a used  megatouch EVO and when I got it, its doesn't work. When I turn it on the fan works and it starts to load, it says no signal and then goes to a page that says  "force intelligent entertainment press TAB to show POST screen, DEL to enter SETUP "and then it just freezes up on that page. I tried hooking up a keyboard to the back to see if that would work and still nothing. Does anyone know anything about these machines? Any info would be great considering I do not know anything about them.

orizzle:
Press DEL to get into setup. Can you see if the hard drive is being detected?

otsep:
I had one that did this until I replaced the motherboard battery.  Pull the battery and check it's voltage.

After replacing/keeping the battery, set DIP switch 8 on the IO board to the down position.  This should reload the CMOS setting and do a test of the system.

I'm not expert, but this has worked for me in the past.

lilshawn:
a failed drive or bad drive cable can cause the computer to sit and wait endlessly for the drive to become available.

have a listen to the harddrive...it should spin up...click a few times then be ready. if it clicks clicks clicks it's toast. if it sounds like it's not spinning up...check your power supply. it should have 12 volts and 5 volts. if it's good. the motor on the drive is probably toast.

ed12:
if it is a Maxtor hard drive ?
u can lean towards toast

ed

Navigation

[0] Message Index

[#] Next page