Author Topic: Arcade monitor V-hold not Holding (Read 2535 times)

Kevin Driscoll · « **on:** July 05, 2002, 05:20:07 pm »

Hello I am new to the message board but form what I see it has a lot of good info but I have a monitor problem looks like others here but mine has a V-hold that I can adjust an it will hold for a while then it start to roll I'D say about 4min after I adjust it the monitor is a G07C60 19" NTSC and I have it hooked up directly to my PC I am running Arcadeos and mame in DOS the games will play fine but after awhile the picture just starts to roll and it drives me crasy. Also dose any know how to setup Callus to run in Arcadeos I can see the ROM

Kevin driscoll · « **Reply #1 on:** July 07, 2002, 01:25:35 am »

Hey I fround out what I was doing wrong with the H and V sec I had set it up to be composit because the monitors H and V sync were jumperd on the board itself.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Arcade monitor V-hold not Holding (Read 2535 times)

Kevin Driscoll

Arcade monitor V-hold not Holding

Kevin driscoll

Re: Arcade monitor V-hold not Holding