Software Support > Automated Projects

Beginners help on Ipac Ultimate and RGB lights

<< < (2/2)

Homietheclown:

--- Quote from: 05SRT4 on May 27, 2015, 02:18:49 am ---I actually just installed the same setup and used the ultimate board. I can confirm you do not need a PacLED. Just make sure you have the LED power cable which I think comes standard.

--- End quote ---

I am in the same situation. Can you tell me exactly where you plug in the RGB connector (from the U-track) into the Ultimate I\O.

05SRT4:
Looking at a picture of the U-track, it looks like the standard RGB blue (plus a ground) you should be able to plug it into any 1 of the 32 LED slots. And if there is a ground wire, just connect to a ground pin.

Navigation

[0] Message Index

[*] Previous page