I have a Pi 2 using Retropie 3.0 beta 2.
I have an Xbox 360 wireless controller which I have configured using a great video from Floob. (I think this site should have a section for all videos, even if just links)
And this link
The controller works well in Emulationstation, but doesnt work in FBA, Mame or snes.
Is there an extra step for FBS etc?
sudo nano XboxGamepad\(userspacedriver\).cfg
Shows this
input_device = Xbox Gamepad (userspace driver)
input_driver = udev
input_b_btn = 1
input_y_btn = 3
input_select_btn = 8
input_start_btn = 9
input_up_btn = h0up
input_down_btn = h0down
input_left_btn = h0left
input_right_btn = h0right
input_a_btn = 0
input_x_btn = 2
input_l_btn = 4
input_r_btn = 5
input_l2_btn = 6
input_r2_btn = 7
input_l3_btn = 11
input_r3_btn = 12
input_l_x_plus_axis = +0″
input_l_x_minus_axis = -0″
input_l_y_plus_axis = +1″
input_l_y_minus_axis = -1″
input_r_x_plus_axis = +2″
input_r_x_minus_axis = -2″
input_r_y_plus_axis = +3″
input_r_y_minus_axis = -3″
input_enable_hotkey_btn = 8
input_exit_emulator_btn = 9
input_menu_toggle_btn = 2
input_load_state_btn = 4
input_save_state_btn = 5
input_reset_btn = 1
input_state_slot_increase_btn = h0right
input_state_slot_decrease_btn = h0left
input_enable_hotkey_btn = 8
input_exit_emulator_btn = 9
In fba2x.cfg it matches
.??
[Joystick]
# Get codes from jstest /dev/input/js0″
# from package joystick
A_1=0
B_1=1
X_1=2
Y_1=3
L_1=4
R_1=6
START_1=9
SELECT_1=8
#Joystick axis
JA_LR=0
JA_UD=1
Confused now as this looks ok.