Main > Driving & Racing Cabinets

Whats the best way to get the shape of Logitech g25 for cutting out dash?

<< < (2/3) > >>

SegaOutrun:
I used birchwood and an exacto knife back when i have my huge MOMO wheel. Its a very thin wood that make it easy to get a clean cut.

Sadly this is the best picture i could find so it was long ago. You can see the outline of the birchwood under the vinyl. I have since upgrade by extending the shaft of my new wheel and hiding the body

RamjetR:
I covered my wheel with cling wrap, then paper machete the base to form a 3D shape. Then when its dry and hardened. I trimmed it with scissors to the right depth I needed. Then placed the model onto the plastic dash panel I was cutting and with a marker pen drew the inside template shape. cut the hole and it was pretty close to spot on.

Fursphere:
One of these things helps...

http://www.amazon.com/General-Tools-6-Inch-Contour-Duplication/dp/B00004T7RA

BadMouth:

--- Quote from: Fursphere on April 09, 2015, 10:00:41 am ---One of these things helps...

http://www.amazon.com/General-Tools-6-Inch-Contour-Duplication/dp/B00004T7RA



--- End quote ---

Had no idea what those were called or how cheap they were.
I'll definitely be ordering a little larger one.

Fursphere:
Took some creative googling to find it, because I couldn't remember what they were called either.   :P   

Navigation

[0] Message Index

[#] Next page

[*] Previous page