Main > Everything Else
Golden Tee 2001 -2006 CHD's and the U53's, Big Buck Hunter, Carnival King
ed12:
in fb
button m
toggles the rest pin from high current to low
also make sure your printer port is set to bi or/st not ecp nor ecd
ed
Loopey1:
Got Ya.
I will try.
Loopey1:
Well, I am on my third computer, thinking My port may not have enough power to drive the fuse bits.
I have tried a P4 box
a P3 box
and my old AMD quad core.
I could try my old 486 100 DOS programmer box, but that will not boot from a USB so I would have to make a 3.5" disk with the files on it.
and this is what I get every time.
ed12:
try this file
it loads a .hex only
no eep
ed
Loopey1:
Same error. ???
I will try another PC again. This was just off my old DOS box so....
Do I need an external 12 Volt power supply on pin 1 of the Atmel? All of the HV programmers I see have an external power supply to reset the fuse bits.....
But none are the simple one I made so... I wonder if that could be a issue? Not enough power to reset the bits?