Main > Driving & Racing Cabinets
My new project - 'Transformer' Standup/Sit down driver cab
BadMouth:
--- Quote from: Cretster on February 02, 2015, 04:54:36 am ---Honestly, I put videos up and no-ones interested now!!
Told you they'd be boring. Lol!!
--- End quote ---
I enjoyed them, just don't spend as much time on BYOAC over the weekend.
It's like watching a space craft slowly move into position for a launch.
Not exciting in itself, but exciting in showing what's to come.
Automated stuff rules.
lolomc2:
Hello Cretster
Impressive job ! I would like to see more ;)
I though about a pinball mecanisum (not sure of the word) which could be use to loack the wheel in place. You just need to power the coil and than, the lock will be opened.
I will post a picture in order to help my English ;) You can install one on each side and get an easy automatism
Regarding the breake and up pedals, I have used this cheap component which is used normally in bed actuator The lengh you can get is about 5''. I have used a set of two. One to move it horizontally and one to move it to the top, for kids also
Never heard about 24VDC (with high amperage) cheap power supply but I know that you can chain two "classic" AT(X) power supply easily. The only thing to take care is about external boxes that should not be connected together.
Good luck for the rest
Cretster:
Thanks for the comments and suggestions!
I now got the 24v PSU for the rams and they move TONS better now. Major improvement. It's in the house now, and tonight I'm collecting a 3 foot long ram to use for opening/closing the front door panel.
Getting close now but I have to re-design the seat to make it more comfy, look better, and look less like granny's rocking chair. Plus to incorporate the rear speakers etc.
Cretster:
Ok - really need to redesign the seat somehow for more comfort. Will have to figure that out. Maybe it can slide forwards or something, with different lock points.
Think I've got the bits I need now for making the screen tilt down a little too.
Have picked up the big ram for the door/seat but not had a chance to see if it will actually fit in there yet!!!
BadMouth:
Maybe move the pedals to the back of the cab?
I see you might have to cut them in half to straddle the ram though.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version