Main > Main Forum

ServoStik 4 Way / Restrictors

(1/5) > >>

newoski:
Hi Guys,

I've got ServoStiks in my bartop and I'm noticing that, if enough pressure is applied, the joysticks can still hit the diagonals...

I'm a total newb so I'm just curious... is this normal?

Not complaining, just unsure if the diagonals should be possible/impossible in 4-way mode?

Thanks!!

Nephasth:
Adjust your switch levers.

newoski:
Could you elaborate? This is my first build... Still learning

PL1:

--- Quote from: newoski on December 13, 2014, 09:19:02 pm ---Could you elaborate? This is my first build... Still learning

--- End quote ---
By slightly bending the lever arm, you change the distance that you have to move the joystick handle to make the actuator press the lever arm into the nub on the microswitch.

By bending the green zone down by just a bit on all the switches, you can tune the stick so that the diagonals are just out of reach.



Green zone = OK to bend
Red zone = Avoid bending

Related thread here.


Scott

newoski:
Thanks PL1,

I'm surpised that they both have the problem... any experience? Is this normal?

Navigation

[0] Message Index

[#] Next page

Go to full version