| Main > Main Forum |
| Trying to identify these spinners I'm thiking of buying. |
| << < (2/2) |
| sin360:
I offered him $35 for one, but he doesn't want to separate them and would rather have $65 for both. For $65 I think I'm better off just spending a little extra and getting the turbo twist 2. I asked someone on here to see if they wanted to split the cost since they where looking for a spinner, but no worries. I'm finishing up this spinner I'm making. So if that works I'll use till I'll buy a turbo twist 2. |
| Louis Tully:
. |
| sin360:
It's a vcr/mouse hack that I found online. Credits go to axeman. Here are some pictures of how it's coming along. The flat piece is just something I had laying around the shop that wasn't going to be too hard to cut through or soft that it will break. I used this 3M 2 part compound to glue the flat piece to the vcr head. I didn't want to screw it because I wanted to lay flat on the bottom of the control panel. Need less to say I've used that compound on fuel tanks before for emergency purposes till a new one came in. So I know it's a strong bond after both surfaces are scuffed up a little. The coupler is 1/4-20 which I drill out half of it just a hair bigger so I can press it on the shaft of the vcr head. On the other end I'm going to be using 1/4 inch threaded rod since 1/4 inch is the size of all the spinner knobs available to my knowledge. The knob I'm using is this which I'm getting from Mc Master Carr. http://www.mcmaster.com/#7354K15 Now I'm just trying to figure out a bracket to hold the mouse pcb in place. I was just testing it holding the pcb and spinning the wheel around. It was moving, but real slow so if anyone has any suggestions on what setting I need to adjust that would be great. I had everything except knob $5.59 , couplers $3 and I got the encoder wheel printed for like $8 at a local shop. They printed 4 to a sheet. It was cheaper then buying or finding some transparent film. I forgot to mention I used hot glue to hold the cd center holder in place. Here is the Axeman's site where I got the info from. http://www.axe-man.org/arcade-spinner-2/?lang=en Here are some WIP pitures. |
| Navigation |
| Message Index |
| Previous page |