Software Support > Automated Projects

automatic numeric display/countup & hold

<< < (3/3)

bimm25e:

--- Quote from: Slippyblade on November 26, 2014, 09:20:20 pm ---Those are awesome little ornaments you got there.  Good call working them into the machine!

I'm a little confused though.  A CR2302 is a 3v battery.  Seems to me that if the ornaments are being run off of a 3v battery that you'd wanna use a 3 volt regulator.  Like this from SparkFun.

--- End quote ---

your confusion is a result of my ignorance.  If all I'd need is a 3V VR then that seems like a simple enough fix for me.  is 800mAh a good target point there? is there any specification of a VR that I need to be aware of besides the voltage?

Navigation

[0] Message Index

[*] Previous page