Main > Main Forum
Slagcoin templates
DietCoke:
Does anyone know which PPI will translate perfectly to the dimensions of a real build? I'd like to print one to these out for template purposes but can't seem to find the right proportions.
http://www.slagcoin.com/joystick/layout.html
PL1:
--- Quote from: DietCoke on November 15, 2014, 03:51:50 pm ---Does anyone know which PPI will translate perfectly to the dimensions of a real build? I'd like to print one to these out for template purposes but can't seem to find the right proportions.
http://www.slagcoin.com/joystick/layout.html
--- End quote ---
Have you tried to print it using MS Paint?
--- Quote from: BadMouth on May 18, 2013, 04:34:20 pm ---If it's smaller than a sheet of paper less your margins, ms paint is still capable of printing actual size.
Make sure the dpi is correct and select "Adjust to 100% actual size" under print options.
--- End quote ---
Scott
Slippyblade:
I just printed one out then compared it to a 1-1/8" hole. Then increased the size of the print, compared again. Took like 2 tries to get close enough. Either that or just paste the image into your graphic program and compare it against the in-program rulers and stretch till it is correct.
Generic Eric:
Oh, the memories!
I thought I hit the bullseye with slagcoin until I had to print. You'll figure it out. The advice is sound. You are not alone.
DietCoke:
I'm glad I'm not the only one to have this question! Thanks to each of you for your tips!
:applaud: