| Main > Main Forum |
| Slagcoin templates |
| (1/3) > >> |
| DietCoke:
Does anyone know which PPI will translate perfectly to the dimensions of a real build? I'd like to print one to these out for template purposes but can't seem to find the right proportions. http://www.slagcoin.com/joystick/layout.html |
| PL1:
--- Quote from: DietCoke on November 15, 2014, 03:51:50 pm ---Does anyone know which PPI will translate perfectly to the dimensions of a real build? I'd like to print one to these out for template purposes but can't seem to find the right proportions. http://www.slagcoin.com/joystick/layout.html --- End quote --- Have you tried to print it using MS Paint? --- Quote from: BadMouth on May 18, 2013, 04:34:20 pm ---If it's smaller than a sheet of paper less your margins, ms paint is still capable of printing actual size. Make sure the dpi is correct and select "Adjust to 100% actual size" under print options. --- End quote --- Scott |
| Slippyblade:
I just printed one out then compared it to a 1-1/8" hole. Then increased the size of the print, compared again. Took like 2 tries to get close enough. Either that or just paste the image into your graphic program and compare it against the in-program rulers and stretch till it is correct. |
| Generic Eric:
Oh, the memories! I thought I hit the bullseye with slagcoin until I had to print. You'll figure it out. The advice is sound. You are not alone. |
| DietCoke:
I'm glad I'm not the only one to have this question! Thanks to each of you for your tips! :applaud: |
| Navigation |
| Message Index |
| Next page |