Main > Main Forum

Dust / Debris Under Artwork

Pages: << < (2/2)

yotsuya:


--- Quote from: ChanceKJ on November 16, 2014, 02:46:59 pm ---Unless it's something directly staring at you all day long you'll be ok. I sliced my art during the install at the dead top centre of my CP and had a mini freak out. It was the smallest thing and I just don't see it, ever. Nicked my t-moulding too. Meh.

The overall finished product masks the tiny blemish.

--- End quote ---

Chance is right. You'll freak out over it for a week, then after that you won't even remember.

newoski:

Thanks guys -- from past experience (on every phase so far for this build) I'm inclined to agree

DeLuSioNal29:

Also, don't point it out to friends who are using the arcade machine.  Most won't even notice, at all.  If you mention it to them though...

D

jdbailey1206:

I completely agree with SavannahLion.  Sometimes it helps to have an extra set of hands to pull the artwork tight while you yourself run the squegee down over the artwork. 

What I also do and may be a little tedious for some is find a led flashlight and run it over the area you are going to apply the artwork to find of there are any areas that contain dirt particles you may not see with the naked eye.  I then mark these areas and clean as needed.

Pages: << < (2/2)

Go to full version