| Main > Project Announcements |
| Wine Barrel Cocktail arcade |
| (1/5) > >> |
| Sshado:
I was inspired by Maximus Barrel of Kong and had to make a cocktail table out of a wine barrel: Here is a total of all the parts used in this build: PartsCostFromWine Barrel$96.12Wine Barrel Products60n1 PCB Jamma Board[Vendor name redacted per rule 5 :police:]Joysticks$25.92Cajun ArcadeJamma Wiring Harness$11.50Cajun ArcadeBlack Push Buttons$16.17Jamma BoardsBlack Player 1&2 buttons$6.75Jamma BoardsService Buttons$1.50Arcade Emulator17" Monitor$20.00Had alreadyMini SLG Dongle$23.00CraftyMechPlywood$25.00Home DepotPaint/Stain$25.99Home DepotMiscellaneous$120.00Home Depot16a Power Supply$22.98AmazonPower Inlet$3.31Amazon15a Fuses$5.00AmazonCord (12 foot)$10.04AmazonPowerstrip 6 Outlet$6.50AmazonWood Glue$6.87AmazonMini Amplifier$19.99AmazonPyle 3.5" Speakers 100 watt$16.36Amazon30 inch 1/2 inch thick glass top$85.00Amazon2 perfect bar stools$300.00CB2Total$900 |
| mvolke1:
Very cool! Nice work! |
| DaOld Man:
Nice job. :applaud: :applaud: :applaud: I like those stools, but sound a little pricey (tight me coming out again.) How did you remove the bands? Did the wood pieces not try to fall apart when you did? |
| Sshado:
Just removing half the bands at a time does not affect the wood pieces, just loosens enough to take the cover out. I used a blunt chisel and a hammer to slowly remove the bands. It was a newer barrel, so the bands were SUPER tight. I think I got tendinitis in my chisel holding hand :( |
| Nephasth:
Building a Revolution next? |
| Navigation |
| Message Index |
| Next page |