Main > Main Forum

Grommet for hole in cabinet

Pages: << < (2/2)

mgb:


--- Quote from: chopperthedog on October 19, 2014, 01:11:56 pm ---

A button with the plunger removed and the bottom cut off works great.


good day.

--- End quote ---

The button bezel works great. I used the same method for bass ports on my cab

IAmDotorg:

I used the SwitchCraft USB and HDMI ports (like the one above) on my cab.

If its a continuous cable, one option is to get a metal disk, like 1.5" in diameter or something drill a hole in the middle of it, paint or powdercoat it to match the cab, and put a rubber grommet in it.

I built a car from the ground up and did quite a few plates like that where I needed a wire passthrough that looked good. (In my case, they were polished aluminum.)

Pages: << < (2/2)

Go to full version