| Main > Main Forum |
| Grommet for hole in cabinet |
| << < (2/2) |
| mgb:
--- Quote from: chopperthedog on October 19, 2014, 01:11:56 pm --- A button with the plunger removed and the bottom cut off works great. good day. --- End quote --- The button bezel works great. I used the same method for bass ports on my cab |
| IAmDotorg:
I used the SwitchCraft USB and HDMI ports (like the one above) on my cab. If its a continuous cable, one option is to get a metal disk, like 1.5" in diameter or something drill a hole in the middle of it, paint or powdercoat it to match the cab, and put a rubber grommet in it. I built a car from the ground up and did quite a few plates like that where I needed a wire passthrough that looked good. (In my case, they were polished aluminum.) |
| Navigation |
| Message Index |
| Previous page |