Main > Driving & Racing Cabinets

G27 for mame

<< < (2/2)

BadMouth:
Profiler software
https://support.logitech.com/en_us/product/11175

jackiabu:
ok thanks men for your help ;D

Now I have a lot of work.

I will update later ...

MrThunderwing:

--- Quote from: jackiabu on October 07, 2014, 02:32:12 pm ---Anyway my current wheel is fine. FGT Rumble 3-in-1

--- End quote ---

I've got an FGT 3-in-1 also. It's such a great budget priced wheel, I picked one up on a bit of a spur of the moment a couple of years ago for about £30 (which is about £12 less than a new PS3 dual shock 3 pad would've cost me at the time) and was amazed how good it was for how little it cost. I've only recently upgraded to a new wheel with proper working force feedback, which admittedly is better, but I still love my FGT 3-in-1.

When Setting up the FGT in MAME back in the day I had the issue of one of the axes registering before anything else showed up unless the pedal was held down halfway, but I think this may have only been when the wheel was in 'combined' mode rather than 'separate'.

jackiabu:
Well after I took apart the old panel of the machine.
I put the G27 and unfortunately Panal not fit the new steering wheel.



There is not enough room for gear shift.
Even palte of the accelerator pedal too much big or long :banghead:




I need a few things:

Build a new panel to fit the G27 wheel. The problem I need to do all that re-wiring again for the I-PAC etc.

Find a place to the shift  transmission. may build a special facility :badmood:

Navigation

[0] Message Index

[*] Previous page