Main > Main Forum
Ultimate IO / Ultrastik 360 options
<< < (2/2)
dkersten:
I can try to get a screenshot of the ipac mapper when I am home, but here is the basic gist of it:

On the main header:
P1 and P2 joysticks are u360 using usb (not connected to UIO)
P3 joystick uses P1 joystick inputs on UIO
P4 joystick uses P2 joystick inputs on UIO
P1 and P2 buttons 1-7, and coin and start are all on labeled inputs on UIO.
4 admin buttons are on the 1A, 1B, 2A, and 2B inputs on UIO
I think I used the p1 and p2 button 8 inputs for left and right mouse click
I used shift functions for p3 and p4 credit (p1 b7 is shift).
I also used the empty pins correlating to ground for the trackball ground, and for some buttons to ground (just slid the 2.54mm pins into the plug harness)

On the other two small headers:
Spinner and trackball are connected to those ports on UIO
 (this disables 2 of the p4 joystick and 3 of the p3 joystick IIRC, maybe other way around)
P3 and P4 buttons 1-4 are on the labeled pins on the UIO (used 2.54mm female pins and a crimper to add these.  Ultimarc sells expansion harnesses, but you can't use them with the trackball and spinner unless you cut and splice those into the expansion harnesses)
I believe I used P3 and P4 start inputs for those buttons too.

I think I only had to modify the keys for the p1 and p2 joystick inputs, along with the mouse buttons, and one of the admin buttons
Navigation
Message Index
Previous page

Go to full version