| Main > Main Forum |
| 3D Printed Atari Yoke Triggers? |
| << < (3/5) > >> |
| RubberB:
--- Quote from: PL1 on September 23, 2014, 01:40:55 pm ---Welcome aboard, RubberB. ;D Check the part number on the right, outside handle-half -- If it is "040093-01 A" it will work with these non-bushing-style thumb buttons. Scott --- End quote --- Thanks PL1! Glad to be here. The serial number on my handle is that one so my interim plan is to use a black screw with a button head, gluing a nut in place on the screw to act as that ridge on the real part. |
| PL1:
--- Quote from: RubberB on September 23, 2014, 04:25:39 pm ---my interim plan is to use a black screw with a button head, gluing a nut in place on the screw to act as that ridge on the real part. --- End quote --- You may also want to use a little heatshrink/tubing so you don't scrape up the hole in the handle. ;D Scott |
| RubberB:
That's a brilliant idea! |
| paigeoliver:
These buttons get reproduced in aluminum every few years whenever the stock starts getting really low again. |
| Generic Eric:
--- Quote from: paigeoliver on September 23, 2014, 05:19:58 pm ---These buttons get reproduced in aluminum every few years whenever the stock starts getting really low again. --- End quote --- Do you have a source? |
| Navigation |
| Message Index |
| Next page |
| Previous page |