Main > Buy/Sell/Trade - non-retail
Arcade side art, CPO, marquee, bezel, etc. printing available Chicago, IL
stpcore:
If it's going UNDER the plexi you wouldn't necessarily need a laminate. The laminate could be useful if applied to the top side but that's personal preference. If you are local I could help you with the plexi application. Send me a PM and I will help you to the best of my ability.
yotsuya:
--- Quote from: stpcore on September 24, 2014, 11:59:48 am ---If it's going UNDER the plexi you wouldn't necessarily need a laminate. The laminate could be useful if applied to the top side but that's personal preference. If you are local I could help you with the plexi application. Send me a PM and I will help you to the best of my ability.
--- End quote ---
I'm in Phoenix.
Basically, I'd like to make my bezels like so: A sheet of plexi, with the printed bezel attached directly to the backside of the plexi so it's all one piece. That way, I don't have to sandwich the art between two pieces of plexi, I don't have to mount the artwork to foamboard, anything like that. To me, that would be idea.
I'd like something that looked like jdbailey's marquee here - on his, I'm sure the art has been printed directly on the plexi, but that's the look I'm going for.
stpcore:
You would need to get your art reverse printed on clear vinyl and then backed with white vinyl (most color printers do not print white which is why you would use white vinyl as the background to fill in those areas that should be white). Now when you apply the clear vinyl with white background to the underside of your plexi it will display correctly (not in a reversed orientation). You could also back the clear vinyl with a piece of white poster board if it was easier.
screamingtiger:
--- Quote from: stpcore on September 12, 2014, 12:04:14 pm ---I do use a textured polycarbonate laminate (upon request) for those that are looking for extra protection for a CPO, bartop side art, etc. I can laminate anything that I print but I don't offer laminating services on any vinyl or materials that I did NOT print. Not sure if that helps?
--- End quote ---
how much per square foot for this PCL?
thehammer12:
I will PM you as I may need some work done soon.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version