Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news


  

Author Topic: Need measurement of side button(s)  (Read 695 times)

0 Members and 1 Guest are viewing this topic.

tma

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 46
    • My Youtube channel
Need measurement of side button(s)
« on: September 11, 2014, 05:39:20 pm »
Hello,
Was wondering if someone with a real Pinball machine would kindly take a couple of measurements for me.
Need measurement of top of glass/metal edge trim down to center of button & front edge to center of button (flipper button).
Best explained in the picture below:



Need measurements X & Y

Thomas

PL1

  • Global Moderator
  • Trade Count: (+1)
  • Full Member
  • *****
  • Online Online
  • Posts: 6438
  • 2013 UCA Awardee
Re: Need measurement of side button(s)
« Reply #1 on: September 12, 2014, 02:35:23 am »
This is what I came up with while researching for a pinball controller. (see sig)

The flipper buttons could be a little bit closer, but no closer than 36.5mm center to center.



Don't just assume these measurements are good for your application -- verify whether the button positions are comfortable for you at the height and angle of your cab.


Scott

  
 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31