Main > Main Forum
control panel plastic
(1/2) > >>
dubstylee:
I am getting ready to purchase the MDF and plastic for my control panel project.  I plan to get 5/8" MDF and 1/8" clear plastic to cover the artwork.  My question is two-fold:  what plastic do you guys recommend, is there a specific kind that is easier to work with than others and/or a type that is less expensive than others?  And the other part is, how do you guys secure the plastic to the control panel?  I am going to have 3/4" t-molding, so that will be flush all around, but just wondering if you guys bolt the plastic to the wood?  Thanks for any input!
dubstylee:
Ah, an add-on question: do you guys know of anywhere to buy the plastic cut-to-size?  I only need 12" x 30", so I do not want to have to buy a full 4' x 8' sheet...
Slippyblade:
Plain old plexi-glass from any home improvement or hardware store.

Also, if your T-molding captures the edge then your button bezels will hold the plexi in place just fine.
PL1:
You may also want to read through Selfie's sticky thread in Woodworking for more info on different materials and working with them.


Scott
darthpaul:
Spend a little more and get Lexan (much stronger than plexi), I wish I had. I accidentally dropped a screw driver on my Control Panel and put a crack in it.
Navigation
Message Index
Next page

Go to full version