Main > Main Forum
Will this cp layout double as a "finger-meat" grinder?!
<< < (5/5)
Le Chuck:
Pop-up spinner:  Go to the boat store and buy two pop-up cleats



Break off the tops and and weld on a base panel and a top panel.  Mount spinner through top panel.  Ensure mounting plate at proper height so spinner top flush with CP.  Doneskies. 
dkersten:
Gonna a lot of depth to do a popup, and a lot of area if you used a plate and popped the plate up.  Cool idea though.  Well, maybe not with a wheel, you would be pushing it down all the time.  Would need a dust washer with felt on it to keep from grinding your art off the CP surface. 

Would be cool though..
drventure:

--- Quote from: Le Chuck on August 28, 2014, 10:51:30 pm ---Pop-up spinner:  Go to the boat store and buy two pop-up cleats



Break off the tops and and weld on a base panel and a top panel.  Mount spinner through top panel.  Ensure mounting plate at proper height so spinner top flush with CP.  Doneskies.

--- End quote ---

That's exactly the kind of mechanism I was looking for. Heavy duty, pretty straightforward to hack.

Very Nice  :applaud:
zanna5910:
Depending on what joystick you get, you may have issues wiring all the switches for the P1 joystick being that tight to the wall.
BGoulette:
Hmm. I was considering either a ServoStik or a U360 for P1. My hope was that a U360 wouldn't cause any issues, and the connections on a ServoStik looked like they'd fit, but if not, I think I could route out a small pocket on the side of that wall. Good observation. Thanks!
Navigation
Message Index
Previous page

Go to full version