Main > Main Forum
help with wiring relay board
jaharr01:
Hey guys I have been MIA for a bit trying to finish this minipin. So complicated, but rewarding. Anyway, all I have left to to do hardware wise is to hook up some solenoids and etc. probably around 4-5 outputs. I bought this: http://www.amazon.com/8-Channel-Relay-Shield-Arduino-STM32/dp/B00G8U9OR6/ref=sr_1_1?s=electronics&ie=UTF8&qid=1409110698&sr=1-1&keywords=12V+8-Channel+Relay+Shield+For+Arduino+2560+ARM+PIC+AVR+STM32+A045. i'm not sure if it will work but it was cheap. I just need some protection for my led wiz. And I don't want to burn my house down, well at least with anyone in it.I get the jist of it but The jumpers threw me off. I was wondering if someone could show me how to wire it up. Possibly with a diagram. I would really appreciate it.
thanks a bunch
Jay
matsadona:
There wasn't much information to be found on that Amazon page, so it is hard to answer.
Did you get any kind of manual? Does the vendor have any online instructions? Isn't there any information/print on the PCB?
I found this picture at the vpforums.org (http://www.vpforums.org/index.php?showtopic=26708)
However that doesn't answer your question about the jumpers.
PL1:
The screw terminals are definitely NO, COM, and NC, wire those the same as above.
What we need to see are all the pins and pin labels for your specific board.
Ground pin should be easy -- connect it to the LEDwiz like above.
Some pins (IN1 - IN8 ?) control the switching of the relay -- looks like pulling the control pins low (applying ground via LEDwiz) closes the relay, wire them the same as above.
The tricky part is getting the right operating voltage for the relays on the right pin and sorting out the jumper. (if any) ;D
Here are some links that might help you narrow down the exact connections and voltages to use.
Diagram showing a similar realy board wired to an arduino here.
Schematic showing the internals of the similar relay board here.
Another post showing a similar board here.
One more post with info that might help is here.
Scott
jaharr01:
I guess I could test it before I install it by hooking it all up manually switching the ground like an LED wiz does. Do I need diodes?
jaharr01:
is this it?