| Main > Main Forum |
| Control Panel Overlay - Apply first, then drill? |
| << < (2/3) > >> |
| shponglefan:
--- Quote from: Slippyblade on August 07, 2014, 07:54:01 pm ---I'm with Yots on this. If you need to, lay the CPO on the CP and use a tiny drill to create some pilot holes in the centers of your button locations. Then drill the wood bare. Attach the CPO and use a razor to cut out the holes. --- End quote --- +1 |
| yotsuya:
Actually, this is the thread where I saw it happen, but unfortunately the photos aren't available anymore. But read the text to see what happened. |
| EMDB:
I first drilled the holes (using the drill template I ordered seperately), than applied the overlay (used a flashlight to light from below to position the overlay) and finale used a router to cut out the holes in the overlay: |
| newmantjn:
Thanks for the information guys. Drill first it is. @EMDB - Did you use a laminate trimmer for that? |
| Benzinbruder:
Check out is build thread over here: http://forum.arcadecontrols.com/index.php/topic,130690.msg1425323.html#msg1425323 |
| Navigation |
| Message Index |
| Next page |
| Previous page |