Main > Reviews

www.hollandcomputers.com

(1/2) > >>

Sarver Systems:
I just wanted to write about an absolutely pleasant experience with Holland Computers. www.hollandcomputers.com

I live near Pittsburgh, and they are based in North Central Ohio.

I ordered the following items:

2 lighted jpysticks
14 lighted buttons
1 tinted cocktail cabinet glass
25 ft of yellow t-molding
1 extra jamma harness
4 glass clips
2 speaker grills
2 speakers
1 volume pot
1 coin door
2 jamma connector label kits

And probably some other items I missed in there too.

Chris handled my order personally, and took care of making sure I had everything I needed.

I chose to drive there to pick up the parts since I always enjoy a good road trip, and I just know UPS would break the glass.

When I arrived, I was greeted with a smile by the person behind the counter. My order was already boxed up and ready to go.

Good thing I went through the order piece by piece because I ordered the wrong coin door. We swapped it out, and I was on my way!

Chris then sent me an email a few days later to verify I was happy with all of my parts.

Yes, Chris. Yes indeed!

Also, there is a coupon code you can use to get 10% off the order. And anything over $1000 is shipped free.

wp34:
I ordered parts for my cocktail cabinet from them and was very happy with their service as well.  I did have the glass shipped and it was packed very carefully.

pbj:
Did you take a look at any of his cabinets while you were there?  I've always wondered about his cocktails...

Sarver Systems:
I looked at all 3 cabs he had there. He had a cocktail, a stand up, and bartop. All were very nice. They looked to be well-built.

I ordered mine from ebarlow. I paid more for my bartop arcades cocktail, but I am happy with it as well. I'll be writing a review for him soon.

emperormax:

--- Quote from: Sarver Systems on August 04, 2014, 02:55:40 pm ---
Chris then sent me an email a few days later to verify I was happy with all of my parts.


--- End quote ---

I concur with your review. I ordered glass for a Gorf cocktail table and had left a message for Chris because I wasn't sure if the glass I needed had a 3.5" radius on the corners or 4" radius.  He held the order and called me and made sure it was right before sending it out.

Max

Navigation

[0] Message Index

[#] Next page