Main > Main Forum
Zippyy short vs long shaft on 1/2" MDF?
<< < (2/2)
PL1:
Precise centering of the mounting plate is your friend.

You may want to go one size smaller (1") for a Zippyy unless you can center the mounting plate fairly well.

If you're too far off-center (~1/4" in 1/2" wood?), the edge of the hole can show.


Scott
roknrol:
Thanks, Scott. Figured I'd ask as I'm in the same situation as the OP. Looking at undermounting a Zippyy long-shaft in 1/2" MDF without additional routering. Just in setting up my templates, I noticed the size differences in the Slagcoin template. BYOAC Wiki didn't specify one way or the other. As I certainly don't want to risk not being able to hit corners, I'll go 1-1/8" and be certain to center it really well. I figured, like Slippy said, the dust washer would cover it.
Navigation
Message Index
Previous page

Go to full version