Main > Main Forum

Are Seimitsu buttons a good alternative to Sanwa?

Pages: (1/2) > >>

fantoboy:

I have a 1/2" thick control panel, which is too thick for the Sanwa screw buttons.  I was going to drill out the bottom, but I see Seimitsu makes a longer screw button.  Are they pretty comparable to Sanwa buttons?

http://www.focusattack.com/seimitsu-ps-14-gn-screwbutton-white/

amendonz:

yes, they are very similar really, just slightly flatter and less shiny finish. feel fairly close in terms of how hard you have to push them to activate the switch

DeLuSioNal29:

I have used them and they are great.  Especially when paired with button silencers from FocusAttack.com  :applaud:

DeLuSioNaL29

BadMouth:

They are good buttons, but I'm not so sure they will work with 1/2" either.

I use the Seimitsu KN buttons which look to be about the same length.  They are in a 1/2" panel, but it's routed out.  I don't think I even considered trying it in the full thickness panel.  I'm pretty sure it won't work, but I'll check when I get home.

I'd contact focusattack and inquire before ordering.

shponglefan:

IMHO Seimitsu buttons are better than Sanwa.

Pages: (1/2) > >>

Go to full version