| Main > Everything Else |
| Rotary Wiring Pinout |
| << < (2/2) |
| BadMojo12:
I had searched for a good pinout and was unsuccessful, harassed poor Andy at Ultimarc and then was finally pointed to the the right page by Scott (although when I saw it I concede that I should have been able to find it). For those that stumbled as I did and for those trying to make their own cable [build rotary joystick cable harness ultimarc interface] I changed my pinout picture per request of Scott below. Also below is a picture of the cable that I used for the interface. That one order ("3 x 40P 20cm Dupont Wire Jumper Cable 2.54 1P-1P Male-Male/Female-Female/Female-Male") provided enough ribbon cable to do both joysticks in a standard panel with the interface located in the middle; it's super easy to work with because you just tear off the stuff that you need and the pins fit perfectly snug together on both the interface and the joystick; you obviously need to use the cable sets end-to-end to reach but there is more than enough in the one $7 order to work. The link to order is as follows: http://www.amazon.com/gp/product/B00BQA5BWU/ref=oh_details_o09_s00_i00?ie=UTF8&psc=1 |
| PL1:
Looks good. :applaud: Just to be sure I understood your earlier post -- P2 Pin 1 on the interface is on the left by the P2 marking, correct? (Not labeled on the pic.) Scott EDIT: P2 Pin 1 is next to the USB conector. See diagram below. |
| spoot:
Son of a squirrel......no wonder I didn't get mine to work right. :censored: And printed for fixing my stuff........ |
| PL1:
Updated pic to label P2 pins 1 and 13 for clarity. (LMK if I got them backwards) Image uploaded and added to the wiki entry here and the other thread here. Scott EDIT: Corrected P2 pin labels -- they were backwards. :embarassed: |
| kerrycorcoran:
BadMojo12, Any chance you could assist me with setting up my Happ Rotary joystick? I have the Ultimarc Controller too. The thing that is confusing me is do I still need to plug in positive/negative leads to the pots? also, why do the pots have 3 posts instead of two? Any help appreciated. Thanks, Kerry |
| Navigation |
| Message Index |
| Previous page |