Main > Main Forum

Mounting question on Minigrip Flight Stick

Pages: << < (3/3)

PL1:


--- Quote from: mgb on June 28, 2014, 10:34:24 am ---I like them also because they space the joystick down just a bit so its not sitting too high up top.
the only thing is, these plates may have a different mounting pattern than that minigrip. The mini grip looks to have the smaller japanese mounting pattern so you would possibly need an adapter like paradise arcades sell.

--- End quote ---
Spacing the joystick down is fine for a ball-top or bat-top, but there's almost no wiggle room on these trigger-sticks.

You'll want a flat plate, especially if you're using plexi on your panel.

They do use the same mounting pattern as an LS-32/Zippyy stick.


Scott

AndyWarne:

This stick has 20mm of clearance on the shaft, below the handle. So should bottom-mount on a 3/4 inch panel with no problems.

Andy

PL1:


--- Quote from: AndyWarne on July 05, 2014, 03:32:54 am ---This stick has 20mm of clearance on the shaft, below the handle. So should bottom-mount on a 3/4 inch panel with no problems.

--- End quote ---


Sorry, Andy, but you're calling THAT 20mm of clearance??!!??  :dizzy:

Cue the obligatory jokes about why women have trouble estimating length.

Perhaps you posted the wrong picture on your site or you're thinking of the short-shaft Zippyy stick instead?


Scott
EDIT: Updated pic from Ultimarc (above) looks like far more clearance than the similar-looking stick that I bought from Paradise Arcade Shop. (below)  Thanks for the clarification, Andy.   :cheers:



AndyWarne:


Just alerted to this thread by a customer. The picture on our site was incorrect, I have now updated it



Pages: << < (3/3)

Go to full version