| Main > Main Forum |
| How often do you swap out your microswitches? |
| (1/4) > >> |
| eds1275:
On my spinal tap machine, I crimped the connectors. It sucked. Took a long time, and my crimp-fu was weak and had to redo them (don't have the right tool.) On this little cocktail machine I am making, I soldered it up in about 20 minutes. I don't imagine that with home use it's going to have many problems, and am considering redoing the wiring on the spinal tap machine to make it neater. I am pretty fast at soldering, and technically good at it (neat looking, uniform etc - I do a lot of it at the theatre I work at and at home with my own audio gear.) |
| DaOld Man:
I soldered most of my switches and have only changed out one (Out of 5 builds to date). Trick is to leave an inch or two extra slack on the wires, then when (and if) a switch fails, cut the wires close to the terminal and solder them back on the new switch. IMHO, soldering is neater, easier, less time consuming, and a much better connection (if you know how to solder.) |
| eds1275:
That's what I thought, but wanted it backed up by experience. |
| mgb:
You should be fine. It's not as likely that switches will fail real often on a home use machine. Basically, if you left a decent amount of slack for future replacement and you are a quick and confident solderer, then replacement should be no big deal. I'm not sure what you use for an iron but its worth it to also keep a butane iron for quick repairs. I would say I use my butane iron more than my plug-ins. It makes for quick work |
| paigeoliver:
I have over 20 games in my house at any given time and I pretty much never have to replace microswitches unless they are already broken when I wheel the game in. I think I have only ever had one go bad on me, and that was one from the 80s. |
| Navigation |
| Message Index |
| Next page |