Main > Main Forum

Mains inlet IEC

Pages: << < (4/4)

s_busby_uk:

That'd be amazing, thanks!

Generic Eric:


--- Quote from: Generic Eric on May 09, 2014, 09:47:42 am ---Search your local hardware store for something like this.  Then you don't have to worry about cutting the end off.

You should buy some heat shrink tubing also to fit over the leads. 

When I looked in my local store, I didn't find any receptacle.  But its supposed to "snap in" To what, I don't know.  Sometimes, they don't even come with fuses. Let alone mounts.


Someone posted a nice picture of the one they did.  Hopefully someone will post it again.

--- End quote ---
The link didn't post.

http://www.amazon.com/Leviton-660-515CV-0CV-Connector-Grounded-Yellow/dp/B000FPCHUQ/ref=pd_cp_hi_3



Sarver Systems:

The dimensions for the cutout are:

1 1/16" W
1 7/8" H

The holes are 1 9/16" apart. I would wait to drill the holes after it has been installed though.

s_busby_uk:

You are a star Sarver Systems, many thanks.

Pages: << < (4/4)

Go to full version