Main > Main Forum

Mini-PAC question regarding ground and 5v wiring

Pages: (1/1)

markc74:

Hi all – I’m hoping Andy (or someone) can help me with a question I have about the Mini-PAC.  I’m specifically using the older model that has a PS/2 keyboard connection.

I’m planning on using swappable controls with the mini-PAC wired to a jamma edge connector. Each swappable control panel will connect via a specially wired jamma connector. The problem I’m having is that I ‘ve ran out of available pins.

Looking at the minipac pinout (http://www.ultimarc.com/Mini-PAC%20Manual1.pdf) it seems I have three separate 5v connections and four separate ground connections.

So – my question is – can I join all the grounds together onto one pin, likewise can I join all the 5v’s together which would mean five overall less connections needed?  If I did would there be any problems with this? i.e. would I have problems with the trackball and/or spinner if everything uses the same ground and power lines?

Any help would be much appreciated before I start on a massive soldering job!


surface tension:

Yes, no problem with that. You can connect all the 5v together and the 0v together.

PL1:


--- Quote from: surface tension on May 06, 2014, 08:21:47 am ---Yes, no problem with that. You can connect all the 5v together and the 0v together.

--- End quote ---

Be sure you don't exceed the current capacity of the remaining wire.


Scott

markc74:

Aces - thanks for the speedy replies chaps!

Pages: (1/1)

Go to full version