Main > Main Forum
Aimtrak guns - software utility won't run.. - SOLVED -
radiofrog:
--- Quote from: chopperthedog on April 26, 2014, 08:16:35 am ---I found that the utility applies changes to the gun itself and used another computer to config gun. Long press of the trigger (10~12 sec default) will get you to calibrate mode on any computer.
--- End quote ---
Interesting. Unfortunately, I don't have an easy way to hook up another computer to that monitor, since it's in my arcade cabinet. And my laptop is a Moc with no VGA hookup.
However, if I were to set up the red dot mode, and make any other setting changes in the utility on another computer, would those then all hold in the gun? If so, I could conceivably do a back-and-forth between two computers to set things up.
AndyWarne:
--- Quote from: radiofrog on April 25, 2014, 10:21:15 pm ---Thanks, I did already try that, though. Same result.
BTW, it's in Win7, 64.
--- End quote ---
Are you sure you didnt hear back as I replied about this very issue a few days ago to someone.
My reply was:
Try locating the Composite Device which is located under the USB Controller entry in Device Manager. Right click and "uninstall" this. Then unplug and reconnect the gun.
radiofrog:
--- Quote from: AndyWarne on April 26, 2014, 05:07:39 pm ---Are you sure you didnt hear back as I replied about this very issue a few days ago to someone.
--- End quote ---
Yes, I'm certain; I was even checking my junk mail box. Anyway, thanks so much for responding here, Andy. Right now, the gun and sensor are unplugged. Does the order in which I proceed from here matter, as far as whether I try to run the utility with either device plugged in or not?
Also, I see 2 USB Composite Devices in Device Manager. Would one of those be for my XArcade stick (w/ trackball)? Would it be wise to ham-handedly uninstall both?
Malenko:
--- Quote from: radiofrog on April 27, 2014, 12:08:48 pm ---Also, I see 2 USB Composite Devices in Device Manager. Would one of those be for my XArcade stick (w/ trackball)? Would it be wise to ham-handedly uninstall both?
--- End quote ---
just unplug the xarcade first
radiofrog:
Dang, I just don't get what's wrong here. I had all devices unplugged and was left with 1 Composite Device. I uninstalled that, then plugged in the sensor and 1 gun. Now Device Manager shows 2 Devices again. Should I be ignoring the sensor for now? Going to tinker some more...